Polytrol is a deep penetrating oil which restores the original colour and appearance of dull or tarnished plastics, gelcoats, metals, and other surfaces.
It penetrates the surface, re-wetting the pigments to restore their lustre and colour which has been lost through exposure to sunlight, rain, and pollution and it also gives corrosion protection. Â When used on tarnished metals, it brings back the shine and gives long-term protection against corrosion.
Simple to apply using a cloth or soft brush, it’s ready to wipe off in just 10 minutes! It can be used on both horizontal and vertical surfaces and can even be used on fibreglass (GRP). Polytrol dries to a tough and long-lasting flexible finish which does not leave a film – so it won’t peel or flake.
Polytrol is now available in a handy 250ml spray can, great for quick application and difficult to reach areas. Please see the directions for use to find out how to apply it.
Ideal Uses for Polytrol Colour Restorer
- Brightening faded car bumpers
- Reviving the gelcoat on your boat
- Restoring the shine to metal fixtures
- Rejuvenating flat or chalky paint dulled by weathering
- Brightening the surface of tiles in stone, terracotta, marble, slate, etc.
- Reviving the colour of faded garage doors
Restrictions
DO NOT use Polytrol on white surfaces, it will not work as Polytrol is designed to restore pigments.
Surface Preparation
All surfaces must be clean, dry and free of dirt, grease, grime and mildew. All waxes, polishes, silicone etc. should be completely and thoroughly removed. Treat any mildew with a 50:50 bleach and water solution. Scrub the solution on to the surface and allow it to stand for 10-15 minutes then rinse thoroughly.
Using Polytrol on plastic, gelcoat, tiles, painted surfaces etc.
Clean the surface with warm soapy water or Net-Trol, rinse thoroughly and allow it to dry for a minimum of 24 hours depending on the surface.
Using Polytrol on stone, brick, etc.
Clean the surface with Net-Trol, rinse thoroughly and allow it to dry for a minimum of 24 hours depending on the surface.
Using Polytrol on metal
Clean the surface with warm soapy water and rinse thoroughly or use an appropriate solvent (follow manufacturer’s instructions). Leave the surface to dry for a minimum of 24 hours.
Application of Polytrol Colour Restorer
General directions
Always work in areas that can be completed 10-20 minutes to ensure an even appearance. If the surface absorbs the Polytrol unevenly (i.e. some matt and some shiny patches) move any surplus oil from shiny areas to matt areas. Wipe off any excess Polytrol with a lint-free cloth before it becomes tacky. For a shinier finish, buff the surface with a lint-free polishing cloth.
When using the Polytrol 250ml spray can, simply spray on liberally, wipe off any excess and leave to dry.
Applying Polytrol to plastic, gelcoat, tiles, painted surfaces etc.
Apply Polytrol liberally and evenly with a brush or cloth. Allow it to work for 10-20 minutes. Wipe off any excess with a clean lint-free cloth. Leave it to dry.
Applying Polytrol to stone, brick, etc.
Apply Polytrol liberally and evenly with a brush or cloth and leave it to work for 10-20 minutes. Brush out or wipe off any excess Polytrol with a clean lint-free cloth. Leave it to dry.
Applying Polytrol to metal
Apply Polytrol using a fine wire wool (000 grade) soaked in Polytrol and allow it to work for 10-20 minutes. Wipe off any excess Polytrol with a clean lint-free cloth. Leave to dry.
Note: Polytrol is not a surface coating. Its place is in the surface, not on top.
Maintenance
Maintenance is due when a Polytrol treated surfaces shows signs of fading. Prepare and re-treat surfaces as directed above.
Clean Up
Clean any tools used with white spirit. Polytrol is non-flammable, however any rags, steel wool etc. soaked in Polytrol may spontaneously catch fire if improperly discarded. Rags, steel wool etc must be saturated with water after use or placed in a sealed, water-filled metal container, before disposing of them with household waste. Rags may be laid flat and air-dried before discarding.
Things to Remember
- Cover and protect everything you do not wish to treat.
- Apply between +5°C and +35°C.
- Do not apply in direct sunlight or on to hot surfaces.
- Do not allow excess Polytrol to dry and create a film on the surface (always remove excess product).
- Do not use Polytrol on white surfaces.
Douglas Graham –
Verified Owner
Our composite front door has a ‘wood’ finish. This had lost it’s colour and looked in
a sorry state. After treating with Polytyrol it now looks as good as new.
An excellent product.
Nick Hooper –
Verified Owner
It’s black magic!! I painted one coat onto a composite plastic mahogany door badly faded by sunlight, and it looked better than new. Took about 30 minutes, including the masking up. Couldn’t have been easier.
Graham Abraham –
Verified Owner
Our mahogany composite front door(south facing) was ten years old and just out of warranty….although I don’t think the company would have replaced it….and was quite badly faded. However, the door company recommended Polytrol and like other reviewers I wasn’t willing to pay almost £2000 for a replacement !!!!
Followed the instructions and it worked. The neighbours thought we had a new door.
Most impressed and hope it will last as the sun can be pretty strong ….. am I able to redo at a later stage if it starts fading again ??
Thanks for saving me a lot of money !!!
Owatrol Team –
Hi Graham,
Thank you for your kind words – we are glad to hear you had such a positive experience with Polytrol.
You can re-apply Polytrol if the surface stars to fade again. Simply clean the area, wait for it to dry and then re-apply the Polytrol in the same way you did before.
If you have any before and after pictures, we would love to see them! – Feel free to send them over to us at sales@owatroluk.com
Thanks again,
The Owatrol Team
Sean Porter –
Verified Owner
Really happy with the results. The plastic is still looking fresh after a month!
L Brown –
Verified Owner
Bought to revive colour to my ten year old black composite door. Worked amazingly ; looks like new. Would definitely recommend and purchase again.
Andy Bale –
Verified Owner
Absolutely outstanding product. I have a 22 year old Ifor Williams horsebox trailer and have been looking for months for a product that would cover / Treat or restore the faded painted side panels. Some of these panels had transfers applied by previous owners. These I had removed which left a darker silhouette on the panels where they had faded around them, which further made the trailer look shabby.
I bought a sample pot of Owatrol colour restorer to try following reading reviews and watching the product video showing its use, hopefull but still not fully convinced it would work. The results on a test patch were awesome the rich red colour was remarkably restored in minutes. I tried it then on the aluminium roof panels , fantastic , shiny like new. I then cleaned the mould of the grey fibreglass front roof panel and was amazed with the same brilliant result of a rich colour returned almost as new. I promptly purchased a Litre of the stuff and set to work on the whole trailer . I and my family are absolutely amazed by the transformation, I am seldom lost for words, but the ease of use, simply brush applied to a clean and dry surface, then wiped over with a cloth to smooth out an even coating, then left to dry , the results have astounded me.
I took before and after photos which I will gladly forward as proof.
Recommend it to anyone . Worth every penny . Does exactly what it says on the tin!!!.
Andy Worrall –
I have tried it on Plastic windows and car Trims, Paint external and internal and it works like magic and you don’t even need very much to do a big area. I will certainly be buying some in the future. Thank you very much.
Richard Smith –
I was recommended to try this on my Morgan….it has red grp wings which had really faded. Having used Polytrol, it has totally changed my car: which is now a nice even red, and shiny!
I have had some great comments from folks. Thanks Polytrol!
Sheila Bowditch –
Verified Owner
Brilliant. This has restored my 11 year old and much faded Composite Red Door back to its former self. So easy to apply and so little required to complete the job. I will be buying this in future for any faded paintwork. I was a little apprehensive when applying this to the door but no need it went on easily and I followed the instructions and buffed it down with a lint free cloth and hey presto! I have what looks like a new door.
Alex –
Brilliant stuff. Absolutely given a new lease of life to my front door. Was looking a little sorry for itself but now like new again. Cannot recommend highly enough